Huawei E180 User Manual

Quick start guide  
Thank you for purchasing  
Huawei E180 HSPA Rotate USB Stick.  
Note:  
This manual briefly describes the preparation, the process for  
installing/uninstalling, and safety precautions for using Huawei  
E180 HSPA Rotate USB Stick (hereinafter referred to as the E180).  
You are recommended to read the manual before using the E180.  
Table of Contents  
Getting to Know the E180  
Requirements for the PC  
Preparing the E180  
Installation Guide  
1
3
5
7
Safety Information  
1
Getting to Know the E180  
The following figures show the appearance of the E180.  
The actual product may differ.  
3
1
2
1
2
3
Micro SD card slot  
Holds the Micro SD card.  
USIM/SIM card slot  
Holds the USIM/SIM card.  
Rotatable USB connector  
Connects to the USB interface of the PC.  
4
Indicator  
Indicates the status of the E180.  
Green, blinking twice every 3s: The E180 is powered on.  
Green, blinking once every 3s: The E180 is registered to the  
GSM/GPRS/EDGE network.  
Blue, blinking once every 3s: The E180 is registered to the  
WCDMA/HSDPA/HSUPA network.  
Green, always on: The GPRS/EDGE connection is set up.  
Blue, always on: The WCDMA connection is set up.  
Cyan, always on: The HSDPA/HSUPA connection is set up.  
Off: The E180 is removed from the PC.  
3
Requirements for the PC  
To use the E180, the PC must meet the following requirements:  
Standard USB interface.  
Windows ꢀ000 SPꢁ, Windows XP SPꢀ, Windows Vista.  
The hardware of your PC must meet or exceed the recommended  
system requirements for the installed version of OS.  
Display resolution: 800 × 600 or above.  
Preparing the E180  
1. Take out of the back cover of the E180.  
ꢀ. Insert the USIM/SIM card and the micro SD card into the  
card slots. Make sure that the cards are properly inserted.  
Note:  
Micro SD card is an optional accessary. If the micro SD card is not  
provided in the package, you can buy one yourself.  
Do not remove the USIM/SIM card and the micro SD card when  
they are being used. Removing the cards during an operation may  
damage the cards as well as the device, and data stored on the  
cards may be corrupted.  
5
Installation Guide  
The procedure for installing the management program depends  
on the operating system installed on your PC. The following section  
takes Windows XP as an example.  
Connecting the E180 with a PC  
Note: Power on your PC before connecting the E180 with the PC.  
Otherwise, the normal installation of the E180 may be affected.  
One way: Plug the E180 into the USB interface of the PC.  
The other way: connect the E180 to a PC using the  
USB extension cable.  
6
Installing the E180 Management Program  
1. Connect the E180 with the PC.  
ꢀ. The OS automatically detects and recognizes new hardware and  
starts the installation wizard.  
Note: If the auto-run program does not respond, find the  
AutoRun.exe file in the driver path. Then double-click AutoRun.exe  
to run the program.  
3. Follow the prompts of the installation wizard.  
ꢁ. After the program is installed, the shortcut icon of the  
management program is displayed on the desktop.  
Launching the Management Program  
After the E180 is installed, the management program is launched  
automatically. Then every time the E180 is connected to the PC,the  
management program is launched automatically.  
You can also double-click the shortcut icon on the desktop to  
launch the management program.  
Uninstalling the Management Program  
1. Choose Start > Control Panel.  
ꢀ. Find the management program, and click Add/Remove Program  
to uninstall the management program.  
Note: It is recommended to restart the PC after the uninstallation  
to ensure that the management program is completely uninstalled.  
Removing the E180  
1. Double-click  
in the system tray. The Unplug or Eject Hardware  
interface is displayed.  
ꢀ. Select the hardware related to the E180 and click Stop.  
3. When the prompt “It is safe to remove the device” is displayed,  
remove the E180.  
Note: Before removing the E180, exit the management program.  
7
Safety Information  
Read the safety information carefully to ensure the correct and safe  
use of your wireless device.  
Interference  
Do not use your wireless device if using the device is prohibited  
or when it causes danger or it interferes with electric devices.  
Medical Device  
Do not use your wireless device and follow the rules and  
regulations set forth by the hospitals and health care facilities.  
Some wireless devices may affect the performance of the hearing  
aids. For any such problems, consult your service provider.  
If you are using an electronic medical device, consult the doctor  
or device manufacturer to confirm whether the radio wave affects  
the operation of this device.  
Area with Inflammables and Explosives  
To prevent explosions and fires in areas that are stored with  
inflammable and explosive devices, do not use your wireless  
device and observe the rules. Areas stored with inflammable  
sand explosives include but are not limited to the following:  
Gas station.  
Fuel depot (such as the bunk below the deck of a ship).  
Container/Vehicle for storing or transporting fuels or  
chemical products.  
Area where the air contains chemical substances and particles  
(such as granule, dust, or metal powder).  
Area indicated with the “Explosives” sign.  
Area indicated with the “Power off bi-direction wireless  
equipmentsign.  
Area where you are generally suggested to stop the engine  
of a vehicle.  
8
Traffic Security  
Observe local laws and regulations while using the wireless  
device. To prevent accidents, do not use your wireless device  
while driving.  
RF signals may affect electronic systems of motor vehicles.  
For more information, consult the vehicle manufacturer.  
In a motor vehicle, do not place the wireless device over the air  
bag or in the air bag deployment area. Otherwise, the wireless  
device may hurt you owing to the strong force when the air bag  
inflates.  
Observe the rules and regulations of airline companies. When  
boarding, switch off your wireless device. Otherwise, the radio  
signal of the wireless device may interfere with the plane  
control signals.  
Safety of Children  
Do not allow children to use the wireless device without guidance.  
Small and sharp components of the wireless device may cause  
danger to children or cause suffocation if children swallow the  
components.  
Environment Protection  
Observe the local regulations regarding the disposal of your  
packaging materials, used wireless device and accessories,  
and promote their recycling.  
WEEE Approval  
The wireless device is in compliance with the essential requirements  
and other relevant provisions of the Waste Electrical and Electronic  
Equipment Directive ꢀ00ꢀ/96/EC (WEEE Directive).  
9
RoHS Approval  
The wireless device is in compliance with the restriction of the use of  
certain hazardous substances in electrical and electronic equipment  
Directive ꢀ00ꢀ/95/EC (RoHS Directive).  
Laws and Regulations Observance  
Observe laws and regulations when using your wireless device.  
Respect the privacy and legal rights of the others.  
Care and Maintenance  
It is normal that your wireless device gets hot when you use  
it. Before you clean or maintain the wireless device, stop all  
applications and disconnect the wireless device from your PC.  
Use your wireless device and accessories with care and in clean  
environment. Keep the wireless device from a fire or a lit cigarette.  
Protect your wireless device and accessories from water and  
vapor and keep them dry.  
Do not drop, throw or bend your wireless device.  
Clean your wireless device with a piece of damp and soft antistatic  
cloth. Do not use any chemical agents (such as alcohol and  
benzene), chemical detergent, or powder to clean it.  
Do not leave your wireless device and accessories in a place with  
a considerably low or high temperature.  
Use only accessories of the wireless device approved by the  
manufacturer. Contact the authorized service center for any  
abnormity of the wireless device or accessories.  
Do not dismantle the wireless device or accessories.  
Otherwise, the wireless device and accessories are not  
covered by the warranty.  
10  
Emergency Call  
This wireless device functions through receiving and transmitting  
radio signals. Therefore, the connection cannot be guaranteed in  
all conditions. In an emergency, you should not rely solely on the  
wireless device for essential communications.  
Specific Absorption Rate (SAR)  
Your wireless device is a radio transmitter and receiver.It is designed  
not to exceed the limits for exposure to radio waves recommended  
by international guidelines. These guidelines were developed by  
the independent scientific organization ICNIRP and include safety  
margins designed to assure the protection of all persons, regardless  
of age and health.  
The guidelines use a unit of measurement known as the Specific  
Absorption Rate, or SAR.The SAR limit for wireless devices is  
ꢀ.0 W/kg and the highest SAR value for this device when tested  
complied with this limit.  
Body Worn Operation  
Important safety information regarding radio frequency radiation  
(RF) exposure.  
To ensure compliance with RF exposure guidelines the device must  
be used with a minimum of 1.5 cm separation from the body.  
Failure to observe these instructions could result in your RF  
exposure exceeding the relevant guideline limits.  
11  
Regulatory Information  
The following approvals and notices apply in specific  
regions as noted.  
CE Approval (European Union)  
The wireless device is approved to be used in the member states  
of the EU. The wireless device is in compliance with the essential  
requirements and other relevant provisions of the Radio and  
Telecommunications Terminal Equipment Directive 1999/5/EC  
(R&TTE Directive).  
Federal Communications Commission Notice (United States):  
Before a wireless device model is available for sale to the public,  
it must be tested and certified to the FCC that it does not exceed  
the limit established by the government-adopted requirement for  
safe exposure.  
The SAR limit adopted by the USA and Canada is1.6 watts/kilogram  
(W/kg) averaged over one gram of tissue. The highest SAR value  
reported to the FCC for this device type was compliant with this limit.  
FCC Statement  
This device complies with Part 15 of the FCC Rules. Operation  
is subject to the following two conditions: (1) this device may  
not cause harmful interference, and (ꢀ) this device must accept  
any interference received, including interference that may cause  
undesired operation.  
* This device should be installed and operated with a minimum distance of ꢀ0 cm between  
the radiator and your body when using it via USB cable.  
Version: V100R001_01 Part Number: 31018885  

MTD 290 003 000 User Manual
Motorola 68000202174 B User Manual
Maxtor ONETOUCH III 400 User Manual
Marantz PMD340 User Manual
LG Electronics Fusic Phone User Manual
JVC KD SX8250 User Manual
JVC KD G827 User Manual
Blackberry 8707 User Manual
Audiovox 811 870091 170 User Manual
Asus Cell Phone M10 User Manual